NEWS CENTER

Clinker bulk machine use and working principle


Release time:

Feb 19,2021

The clinker bulk machine is a special distribution equipment for cement plant clinker loading or loading. Can also be used for building materials, metallurgy, coal and chemical industry and other industries of non-corrosive dry bulk material loading or loading operations. Its main technical indicators have reached the level of similar products abroad, in the domestic leading level.

1. clinker bulk machine use

clinkerbulk machineIt is a special distribution equipment for cement plant clinker loading or loading. Can also be used for building materials, metallurgy, coal and chemical industry and other industries of non-corrosive dry bulk material loading or loading operations. Its main technical indicators have reached the level of similar products abroad, in the domestic leading level.

The equipment has the characteristics of automatic positioning, automatic tracking of material level detection, low energy consumption, smooth unloading, large loading capacity, dust-free loading, loading and so on. It can be installed at the bottom of the warehouse directly for the bulk distribution of cars and trains, or at the middle or end of the conveying equipment for loading or loading.

2. clinkerbulk machineStructure form

The clinker bulk machine is composed of manual rod valve, pneumatic arc valve, feeding device, sleeve type telescopic bulk blanking head, automatic positioning loose rope switch device, upper limit device, electric lifting and hoisting device, automatic tracking material level detector and special electric control cabinet, etc. It is extremely convenient to install and maintain. The cement clinker bulk machine is equipped with dust collection interface, and dust-containing gas during loading is pumped to the dust collector through the dust collection interface and discharged after purification, which can realize dust-free operation, the automatic tracking material level controller configured on the bulk machine can reliably control the electric hoisting device to automatically raise and lower the bulk blanking head according to the set conditions, or automatically alarm and stop when the material is full.

3. clinkerbulk machineWorking principle

Before unloading, open the rod valve and adjust the corresponding rod quantity and discharge amount. When the clinker carrier or vessel enters the loading position, press the "lower" button of the control device to lower the bulk blanking head to the feed inlet of the carrier or vessel or to the designated loading position. After it is in place, the loose rope switch device automatically disconnects the lifting motor, the power supply enters the state of preparing for loading, and then press the "loading" button to load or ship the pneumatic rod valve. Dust-containing gas in the charging process is pumped through the interlayer channel in the telescopic sleeve from the dust collection interface to the dust collector for purification and discharge. The work site can realize dust-free operation. When the material of the lower material head is full, the material level detector of the lower material head sends a signal, the lower material head rises, and the rising distance shall be set before charging. If the rising distance is I m, the time of the time relay shall be adjusted to T = I/V. The loading is still in progress during the lifting process. When the set position is reached (controlled by the material level switch), the pneumatic arc valve is closed or the electric vibration machine is reversed, and other corresponding equipment stops working. If the loading needs to be stopped under special circumstances during loading or loading, the "stop" button can be directly pressed, and then the "rise" button can be pressed to make the dust cover leave the preset highest limit position.