NEWS CENTER

How to Solve the Sprinkle of Plate Chain Bucket Elevator


Release time:

Feb 03,2021

Plate chain bucket elevator but may be affected by some factors and sudden problems, which is more serious, plate chain bucket elevator material can be divided into two cases, that is, in different locations. The following is a board chain bucket elevator manufacturer to explain the reasons for these two situations.

  plate chain bucket elevatorIn most cases, it can generally maintain a good and stable working condition.

Plate chain bucket elevator but may be affected by some factors and sudden problems, which is more serious, plate chain bucket elevator material can be divided into two cases, that is, in different locations. The following is a board chain bucket elevator manufacturer to explain the reasons for these two situations.

  plate chain bucket elevatorThe spilled material at the transfer point is mainly the drop hopper, the guide chute, etc. Usually, when the plate chain bucket elevator is seriously overloaded, the guide chute stopper rubber skirt of the plate chain bucket elevator is damaged, or the steel plate at the guide chute is designed to be far away from the scraper rubber skirt plate, the spilled material phenomenon will occur. The plate chain bucket elevator can see the cause of the spilled material, as long as the movement capacity of the plate chain bucket elevator is controlled within a reasonable range, and the maintenance and maintenance of the equipment are strengthened, similar problems can be avoided and the impact on the conveying process can be reduced.

Another is inplate chain bucket elevatorWhen the concave section is suspended, when the curvature radius of the concave section of the machine is small, the scraper will be suspended. At this time, the situation of the scraper into the groove changes, because the scraper has left the groove roller group. Therefore, once the trough angle becomes smaller, some materials will be scattered. In order to avoid the occurrence of similar situations, in the design of plate chain bucket elevator should be used as much as possible when the larger concave curvature radius, the improvement effect will be very obvious, if the concave section has been designed as no arc transition interval, its width margin can not be too small, otherwise the same problem will occur.

In short, reasonable structural design, scientific assembly in place, correct operation and use, as well as regular maintenance and other aspects of the situation. The plate chain bucket elevator can maintain the normal working mode and reduce unnecessary faults.